Raritan PM Series User Manual

Chapter 5: Using the Command Line Interface
457
config:# role modify <name> addPrivileges
<privilege1>:<argument1>,<argument2>...;
<privilege2>:<argument1>,<argument2>...;
<privilege3>:<argument1>,<argument2>...;
...
Variables:
• <name> is a string comprising up to 32 ASCII printable characters.
• <privilege1>, <privilege2>, <privilege3> and the like are names of the
privileges assigned to the role. Separate each privilege with a
semi-colon. See
All Privileges (on page 453).
• <argument1>, <argument2> and the like are arguments set for a
particular privilege. Separate a privilege and its argument(s) with a
colon, and separate arguments with a comma if there are more than
one argument for a privilege.
Remove specific privileges from a role:
config:# role modify <name> removePrivileges
<privilege1>;<privilege2>;<privilege3>...
If a specific privilege contains any arguments, add a colon and the
argument(s) after that privilege.
config:#
role modify <name> removePrivileges
<privilege1>:<argument1>,<argument2>...;
<privilege2>:<argument1>,<argument2>...;
<privilege3>:<argument1>,<argument2>...;
...
Note: When removing privileges from a role, make sure the specified
privileges and arguments (if any) exactly match those assigned to the
role. Otherwise, the command fails to remove specified privileges that
are not available.
Variables:
• <name> is a string comprising up to 32 ASCII printable characters.
• <privilege1>, <privilege2>, <privilege3> and the like are names of the
privileges assigned to the role. Separate each privilege with a
semi-colon. See
All Privileges (on page 453).
• <argument1>, <argument2> and the like are arguments set for a
particular privilege. Separate a privilege and its argument(s) with a
colon, and separate arguments with a comma if there are more than
one argument for a privilege.

Raritan PM Series Specifications

General

Brand	Raritan
Model	PM Series
Category	Measuring Instruments
Language	English