4 | How to work with the unit
24 / 100 Operating instructions
NOTICE
Improper handling of the hand shower
If you pull the hand shower out beyond the maximum hose length or rip the hose, the automatic retraction
system of the hand shower may be damaged. Then hand shower will no longer automatically retract into the
housing.
1. Do not pull the hand shower beyond the maximum hose length.
1. Pull the hand shower at least 20 cm out of the parked position.
2. Hold the hand shower hose firmly.
3. Turn the front part of the hand shower to select the desired spray pattern.
n
Set the hand shower to to select the jet spray pattern.
n
Set the hand shower to to select the spray pattern.
If you do not turn the front part of the hand shower to one of the two spray patterns, water can drip from the
shower head.
1. Press the lever on the hand shower. The harder you press the lever, the stronger the water stream will be.
2. After use, let the hand shower slowly retract into the housing. CAUTION!Make sure that the hose of the
hand shower is clean before letting it retract into the housing.
4.13 Adjusting the unit height (optional)
If your unit has the height adjustment option, you can set the height of the unit on the display. This enables you to
improve the ergonomics of your workplace.
WARNING
If the unit's height has been set so that the distance to the containers is too great, hot food may spray out
when unloading the unit
You may scald yourself if you touch hot food.
1. Always set the unit so that you can safely unload both pans.
WARNING
If there are containers on the unit and you change the height of the unit, the containers may fall down
You could injure yourself if containers fall.
You could scald yourself if containers filled with water fall into a pan filled with hot oil.
1. Do not place any objects on the unit.
CAUTION
Risk of crushing during height adjustment
There is a risk of crushing when you are setting the height of the unit and there are persons within the unit's
work space.
1. Make sure there is nobody standing within the unit's work space before you set the unit's height.
CAUTION
The unit's height cannot be adjusted at all or cannot be adjusted smoothly
If the height adjustment mechanism is defective, the unit may sink to the lowest point. There is a risk of injury.
1. Do not adjust the height of the unit any more.
2. Contact your RATIONAL Service Partner.