USING SERVICE PROGRAM MODE
SM 5-3 B044/B045/B046
Service
Tables
5.1.1 SP MODE TABLES
NOTE: 1) An asterisk (*) after the SP number means that this SP's value is stored
in the SRAM. If you do a RAM reset, all these SP settings will be
returned to their factory defaults.
2) In the Function/[Setting] column:
• Comments are in italics.
• The setting range is enclosed in brackets, with the default setting
written in bold.
• DFU stands for Design/Factory Use only. Values marked DFU
should not be changed.
• IAJ means that you should refer to Section 3.13 ("Replacement and
Adjustment – Copy Image Adjustments") for more information. IP
means that you should refer to Section 6.7, (Detailed Descriptions –
Image Processing").
SP1-XXX (Feed)
1
Mode Number/Name Function/[Setting]
Leading Edge Registration
1 Paper tray (copy, fax)
2 Bypass (copy fax)
4 Paper tray (optional
printer)
001*
5 Bypass (optional
printer)
Adjusts the plotter leading-edge registration from each
paper feed station. Use the Trimming Area Pattern (SP5-
902, No.10) to make the adjustment.)
[–9.0 ~ 9.0 / 0.0 / 0.1 mm/step] IAJ
• Specification: 0
±
2 mm
• Use the ! key to select “+” or “–” when entering the
value.
Side-to-Side Registration
1 1st tray
2 2nd tray
002*
5Bypass
Adjusts the printing side-to-side registration from each
paper feed station. (Use Trimming Area Pattern (SP5-902,
No.10) to make the adjustment.) The 2nd-tray adjustment
is for the optional tray.
[–9.0 ~ 9.0 / 0.0 / 0.1 mm/step] IAJ
• Specification: 0
±
2 mm
• Use the ! key to select “+” or “–” when entering the
value.
Paper Feed Timing
1 1st tray
2 Other trays
003*
3Bypass
Adjusts the amount of buckle the paper feed clutch
applies to the paper (by adjusting delay between
triggering of the registration sensor and activation of
registration clutch). A higher setting applies greater
buckling.
[0 ~ 10 / 5 / 1 mm/step]
Fusing Temperature Display106
1 Displays the fusing temperature.
Press ! to exit the display.
To Next Page
Loading...
