BIT SWITCHES
SM 5-17 B465
Fax Unit
B465
5.2.3 PLOTTER SWITCHES
Plotter Switch 00
No. FUNCTION COMMENTS
0 Page separation mark
0: Disabled
1: Enabled
0: No marks are printed.
1: If a received page has to be printed out on two
sheets, an asterisk inside square brackets is printed
at the bottom right hand corner of the first sheet,
and a “2” inside a small box is printed at the top right
hand corner of the second sheet. This helps the
user to identify pages that have been split.
1 Repetition of data when the
received page is longer than
the printer paper
0: Disabled 1: Enabled
0: The next page continues from where the previous
page left off.
1: The final 10 mm of the previous page are
repeated at the top of the next page.
2–7 Not used Do not change these settings.
Plotter Switch 01
No. FUNCTION COMMENTS
0 Reset the fusing unit failure
0: Off
1: On (Clear)
When a fusing error occurs, set this bit to 1 after
fixing the problem. The machine then resets the
fusing error. Switch the machine off/on and this bit
will reset itself to 0.
1–7 Not used Do not change these settings.
Plotter Switch 02 - Not used (do not change any of these settings)
Plotter Switch 03
No. FUNCTION COMMENTS
0
Length reduction of received
data
0: Disabled 1: Enabled
0: Incoming pages are printed without length
reduction.
(Page separation threshold: Plotter Switch 03, bits 4
to 7)
1: Incoming page length is reduced when printing.
(Maximum reducible length: Plotter Switches 04, bits
0 to 4)
1–3 Not used Do not change these settings.
To Next Page
Loading...
