BIT SWITCHES
B465 5-18 SM
Plotter Switch 03
No. FUNCTION COMMENTS
4–7 Page separation threshold (with reduction disabled with switch 03-0 above)
If the incoming page is up to x mm longer than the length of copy paper, the excess
portion will not be printed. If the incoming page is more than x mm longer than the
length of copy paper, the excess portion will be printed on the next page.
The value of x is determined by these four bits.
Hex value of bits 4 to 7 x (mm)
0 0
1 1
and so on until
F 15
Default setting: 6 mm
Cross reference
Length reduction On/Off: Plotter Switch 03, Bit 0
Plotter Switch 04 and 05
No. FUNCTION COMMENTS
0–7 Reduction ratios used for different paper sizes (with reduction enabled in switch 03-
bit 0 above)
If reduction is enabled, the data will be reduced in the lengthwise direction before
printing.
These switches determine the maximum reduction ratio for each paper size.
Cross-reference
Switch 04/05 Paper used
Bit0 A5 sideways/HLT sideways
Bit1 Not used
Bit2 LT/B5
Bit3 A4
Bit4 F
Bit5 LG
Bit6 Not used
Bit7 Not used
SW04 SW05 Reduction Ratio
0 0 Disabled
10 4/3
01 8/7
1 0 12/11
Plotter Switch 06 - Not used (do not change any of these settings)
Plotter Switch 07 - Not used (do not change any of these settings)
Plotter Switch 08 - Not used (do not change any of these settings)
Plotter Switch 09 - Not used (do not change any of these settings)
Plotter Switch 0A - Not used (do not change any of these settings)
Plotter Switch 0B - Not used (do not change any of these settings)
Plotter Switch 0C - Not used (do not change any of these settings)
To Next Page
Loading...
