USER PROGRAM MODE
B441 3-8 SM
3.6 USER PROGRAM MODE
Press the “User Tools/Counter ”, then select “Printer Features” to change
printer settings.
User Mode Table
Category Function menu
Tray Priority / Default: Tray1
Tray Locking / Default:None
Standard Size
Paper Input
Bypass Paper Size
Custom Size
Edge Smoothing / Default: On
PCL / Default: 600dpiResolution
PS / Default: 600dpi
Print Quality
Toner Saving / Default:Off
I/O Time Out/ Default: 30sec.
I/O Buffer/ Default: 32KB
Prints PS Errors/ Default: Off
Page Protect/ Default: Auto
Auto Continue/ Default: Off
System
Sub Paper Size/ Default: Off
Orientation/ Default: Portrait
Form Lines/ Default: 64(Metric) 60(inch)
Font Source/ Default: Internal
Font Number/ Default: 0
Point Size/ Default: 12.00
Font Pitch/ Default: 10.00
Job Control
PCL menu
Symbol Set/ Default: Roman-8
IP Address/ Default: All zero
Subnet Mask/ Default: 255.000.000.000
Network Setup
Gateway Address/ Default: All zero
Restart Printer
Menu Reset
Maintenance
Hex Dump/ Default: Off
Configuration Page
Menu List
PCL Pont List
List Print
PS Font List
To Next Page
Loading...
