IMAGE TRANSFER
SM 3-25 B044/B045/B046
Replacement
and
Adjustment
3.9 IMAGE TRANSFER
3.9.1 IMAGE TRANSFER ROLLER
1. Right door (☛ 3.3.9)
2. Raise the levers ([A], [B]) at the ends
of the image transfer roller, and
remove the roller [C].
NOTE: 1) Note the position of the
2 springs [D] at each end.
When reinstalling the roller,
be sure that the pegs on the
plastic end pieces fit into the
springs.
2) Do not touch the transfer
roller surface with bare
hands.
3.9.2 ID (IMAGE DENSITY) SENSOR
1. Right door (☛ 3.3.9)
2. Push in the latches as shown, and pry off
the entire section [A].
3. ID sensor [B] (" × 1)
NOTE: This machine has no SC codes for ID sensor errors. If imaging
problems occur, such as dirty background, use SP2-221. Use SP7-911
to check the number of ID sensor errors.
B046R915.WMF
B046R914.WMF
B046R913.WMF
[C]
[A]
[B]
[A]
[B]
[D]
To Next Page
Loading...
