USING SERVICE PROGRAM MODE
SM 5-33 B044/B045/B046
Service
Tables
SRAM Data Download (SP5-825)
NOTE: 1) Be sure to turn off the main switch before inserting or removing the
flash memory card. Installing or removing a card while the main switch
is on may damage the FCU.
2) This operation will overwrite all of the machine's current SRAM data.
1. Turn off the main switch.
2. Insert the flash memory card [A] into the card slot, with the card's "B" side
facing the rear of the machine. (See illustration on page 5-32.)
3. Turn on the main switch.
4. Access SP 5-825.
5. Enter "1" at the keypad, and then press OK.
6. The machine executes the download. This operation takes about 2 seconds.
On successful completion, the screen displays "Loading completed."
NOTE: If uploading fails, the "Loading error!!!" message appears. If this occurs,
try repeating the procedure.
7. Turn off the main switch, then remove the memory card.
5.1.10 SERIAL NUMBER INPUT (SP5-811)
Use this SP to input the machine's 11-digit serial number. (This is normally done at
the factory). Each key of the numeric keypad controls a different digit of the serial
number: the first key controls the first digit, the second key controls the second
digit, and so on. (The ' key is not used.) Press each key as many time as
necessary to set the corresponding digit. To set the second digit to "X", for
example, press the 2 key as many times as necessary to bring up "X" on the
screen.
Note that the first four digits of the serial number may be either letters or numbers.
Digits 5 to 11 are always numbers.
"()
1st digit 2nd digit 3rd digit
*+,
4th digit 5th digit 6th digit
$-.
7th digit 8th digit 9th digit
! #'
10th digit 11th digit Not used
To Next Page
Loading...
