DEDICATED TRANSMISSION PARAMETERS
B465 5-42 SM
5.4 DEDICATED TRANSMISSION PARAMETERS
Each Quick Dial Key and Speed Dial Code has eight bytes of programmable
parameters allocated to it. If transmissions to a particular machine often experience
problems, store that terminal’s fax number as a Quick Dial or Speed Dial, and
adjust the parameters allocated to that number.
The programming procedure will be explained first. Then, the eight bytes will be
described.
5.4.1 PROGRAMMING PROCEDURE
1. Make sure the machine is in standby mode. Press ‘User Tools’ key then
choose ‘4. Fax Features’.
2. Select the “1. Program/Delete”, then press “OK” key.
Select “1. Prog. Quick dial” or “3. Prog. Speed Dial” then press “OK” key
Example: Change the Parameters in Quick Dial 01.
3. Press Quick Dial key 01 and “OK” key.
NOTE: The selected Quick or Speed Dial must be programmed beforehand.
4. When the programmed dial number is displayed, press S - V - C using Quick
Dial keys, then press ‘Start’.
5. The settings for byte 0 are now displayed. Press a number from 0 to 7
corresponding to the bit that you wish to change.
Example: Change bit 7 to 1: Press 7
6. To scroll through the parameter bytes, either:
Select the next byte: press ‘→’ Switch’
or
Select the previous byte: press ‘←’ Switch’ until the correct byte is displayed.
Then go back to step 6.
7. After the setting is changed, press “OK” until “Programmed” displays.
8. To finish, press ‘User Tools’.
To Next Page
Loading...
