FUSING
B044/B045/B046 3-14 SM
3.5.3 HOT ROLLER STRIPPER PAWLS
1. Fusing unit (☛ 3.5.1)
2. Separate the fusing unit into two sections: the hot roller section [A], and the
pressure roller section [B]. (! × 2)
NOTE: After removing the screws, lower the pressure roller section about
halfway and then slide it toward the front side to detach it.
3. Hot roller stripper pawls [C] (1 spring for each pawl)
NOTE: 1) To remove the right pawl, first remove the plastic spacer at [D]
(! × 1).
2) When reinstalling the center pawl, be sure to set roller [E] back
into place.
B046R507.WMF
B046R502.WMF
[A]
[B]
[C]
[E]
[D]
To Next Page
Loading...
