USING SERVICE PROGRAM MODE
SM 5-5 B044/B045/B046
Service
Tables
2
Mode Number/Name Function/[Setting]
Erase Margin Adjustment
1 Leading edge Adjusts the leading edge erase margin.
[0.0 ~ 9.0 / 3.0 / 0.1 mm/step] IAJ
Does not apply to 1-sheet bypass feed.
4 Trailing Adjusts the trailing edge erase margin.
[0.0 ~ 9.0 / 4.0 / 0.1 mm/step] IAJ
Does not apply to 1-sheet bypass feed.
5 Left side Adjusts the left edge erase margin.
[0.0 ~ 9.0 / 2.0 / 0.1 mm/step] IAJ
6 Right side Adjusts the right edge erase margin.
[0.0 ~ 9.0 / 2.0 / 0.1 mm/step] IAJ
11
1-sheet bypass
leading edge
Adjusts the leading edge erase margin for 1-sheet bypass.
[0.0 ~ 9.0 / 4.5 / 0.1 mm/step] IAJ
101*
12 1-sheet bypass
trailing
Adjusts the trailing edge erase margin for 1-sheet bypass.
[0.0 ~ 9.0 / 4.5 / 0.1 mm/step] IAJ
Development Bias Adjustment
1 Image area Adjusts the voltage applied to the development roller
when printing.
[–800 ~ 0 / –600 / 1 V/step]
• This can be adjusted as a temporary measure if faint
copies are being produced due to an aging drum.
201*
2 ID sensor pattern Adjusts the voltage applied to the development roller
when generating the ID sensor pattern.
[0 = N (200 V) / 1 = H (240 V) / 3 = HH (280 V) / 4 = LL
(120V)]
The actual voltage applied is this setting – 600V.
Copies after Toner Near End213*
1
Sets the number of copy/print/fax pages that can be made
after toner near-end has been detected.
[0 = 50 pages / 1 = 20 pages]
Reduce the number of pages if the user normally makes
copies with a high image ratio.
Initial Developer Running214
Initializes the developer (by forced churning).
[0 = No / 1 = Yes]
• To start forced developer initialization, you must turn the
machine off and back on.
• Since the machine automatically initializes the developer
when a replacement PCU is installed, there is no need
to carry out this SP when replacing the PCU.
• If the machine has not been used for a long period of
time, prints may have a dirty background. In this case,
use this SP to mix the developer.
To Next Page
Loading...
