USING SERVICE PROGRAM MODE
B044/B045/B046 5-10 SM
4
Mode Number/Name Function/[Setting]
Exposure Lamp ON902*
Lets you turn the exposure lamp on and off.
[0 = Lamp Off / 1 = Lamp On]
• To turn the exposure lamp on, press “1”. To turn the
lamp off, press "0". To exit, press
!
or Cancel to exit.
• The scanner moves to the shading position and remains
there until you exit the SP.
• The display also shows the minimum and maximum
white-plate values (updated every 0.5 sec.).
SBU Auto-Adjustment908
1 Performs auto scanner adjustment.
[0 = No (normal operation) / 1 = Yes (start adjustment)]
• Use this SP after replacing the white plate, FCU, or lens
block, and after executing a Memory All Clear (SP5-
801).
• (
☛
IAJ, “Standard White Density Adjustment”.)
DF Shading Interval Time913*
1 Adjusts the interval used for shading processing in DF
mode.
[0 ~ 255 / 30 / 1s/step]
• Setting this value to 255 will switch off auto-shading
between pages of DF copy jobs.
• Light and heat may affect scanner response. Reduce
this setting if copy quality indicates that the white level is
drifting during DF copy jobs.
921* Image Adjustment Selection
1
Use this to select the processing mode (pattern) that you
wish to set adjustment parameters for. After selecting the
mode, you can set the adjustment parameters for that
mode using SPs 4-922 to 4-966. IP
There are 11 modes ("Pattern 1" to "Pattern 11"), as
follows.
1 = Text 1 7 = Special 3
2 = Text 2 8 = Fax Text 1 ("text sharp")
3 = Photo 1 9 = Fax Photo 1 "(photo smooth")
4 = Photo 2 10 = Fax Photo 2 ("photo normal")
5 = Special 1 11 = Fax Text 2 ("text dropout")
6 = Special 2
First use the right or left cursor key to select the mode
["Pattern 1" to "Pattern 11"], and then press "1" to enable
adjustment for that mode. Then press OK, and then
proceed to use SPs 4-922 to 4-966 to make adjustments.
• If you press "0" and then press OK, SPs 4-922 to 4-966
will not operate.
To Next Page
Loading...
