USING SERVICE PROGRAM MODE
SM 5-15 B044/B045/B046
Service
Tables
5
Mode Number/Name Function/[Setting]
SC Code Reset810
Resets all level-A service call conditions, such as fusing
errors.
[0 = No / 1 = Yes]
• After selecting “1”, hold down the Original Type key and
press the OK key (or the ' key) to execute the reset. If
the reset succeeds, the machine reboots. If it fails, the
display shows “Error!!!”.
• (
☛
4.1, "Service Call Conditions")
Serial Number Input811*
Used to input the machine serial number (normally done
at the factory). This is the serial number printed on SMC
reports. (
☛
5.1.10)
Service Telephone Number812*
Use this to input the telephone number of the service
representative. (This number is displayed when a service
call condition occurs.)
• To input a dash, press ! .
• Use % to delete the existing phone number or to delete
the last digit that you entered.
SRAM Data Upload824
Uploads SP and UP settings from the machine's SRAM to
a flash memory card.
(
☛
5.1.9)
[0 = No / 1 = Yes]
• This SP is effective only if a flash memory card has been
plugged into the machine’s card slot.
SRAM Data Download825
Downloads SP mode data from a flash memory card to
the machine's SRAM.
(
☛
5.1.9)
[0 = No / 1 = Yes]
• This SP is effective only if a flash memory card has been
plugged into the machine’s card slot.
Program Upload826
Uploads the system program from the machine's SRAM
into the flash memory card plugged into the machine's
card slot.
(
☛
5.1.8)
[0 = No / 1 = Yes]
• This SP is effective only if a flash memory card has been
plugged into the machine’s card slot.
Program Download827
Downloads the system program from a flash memory card
to the machine's SRAM.
(
☛
5.1.8)
[0 = No / 1 = Download first 2MB / 2= Download last 2MB]
• This SP is effective only if you have booted the machine
from a flash memory card.
To Next Page
Loading...
