Ricoh aficio 1013F - 6.17 ENERGY SAVER MODES

ENERGY SAVER MODES
B044/B045/B046 6-50 SM
6.17 ENERGY SAVER MODES
6.17.1 MODE TRANSITIONS
When the machine is idle, the energy saver function reduces power consumption
by lowering the fusing temperature. As shown below, the machine can be set to
transition to two different reduced power states, in the following order:
1) Low power mode
2) Auto-off mode
Above, if the Energy Saver Timer setting is x and the Auto Off Timer setting is y,
then the following operation applies:
• If x < y: The machine moves into selected low-power mode if all sensors and
components remain inactive for time x, then moves into auto-off mode
if all sensors and components continue inactive for time y-x.
• If x ≥ y: The machine skips low-power mode and moves directly into auto-off
mode if all sensors and components remain inactive for time y.
Note that during countdown to x or y, the machine may automatically switch into
the preferred application mode (copier/fax) in accordance with the User Tool's
Function Priority and System Reset settings. This has no effect on the power-
mode transition timing.
Low Power Mode
Auto-Off Mode
Standby
Mode
Auto-Off Timer (
y
)
Default: 30 min
Machine idle for time (
y
-
x
)
(where
y
>
x
)
Energy Saver Timer (
x
)
Default: 15 min
"Wake-up" action
(See 6.17.5.)
"Wake-up" action
(
See 6.17.5.
)
Machine idle for time
x
(where
x
<
y
)
Machine idle for time
y
(where
y<
x
)
B046D574.WMF