Ricoh aficio 1013F - Page 297

BIT SWITCHES
SM 5-25 B465
Fax Unit
B465
Communication Switch 14
No. FUNCTION COMMENTS
5 Not used Do not change the setting.
6, 7 Available unit of resolution in
which fax messages are
received
Bit 7 Bit 6 Unit
00mm
01inch
10mm and
inch
(default)
11Not used
For the best performance, do not change the factory
settings.
The setting determined by these bits is informed to
the transmitting terminal in the pre-message
protocol exchange (in the DIS/NSF frames).
Communication Switch 15
No. FUNCTION COMMENTS
0, 1 Available resolution for
receiving fax messages
Bit 0 1: 200 x 100/8 x 3.85
Bit 1 1: 200 x 200/8 x 7.7
Other bits: Not used
For the best performance, do not change the factory
settings.
The setting determined by these bits is informed to
the transmitting terminal in the pre-message
protocol exchange (in the DIS/NSF frames).
2–7 Not used Do not change these settings.
Communication Switch 16 - Not used (do not change any of these settings)
Communication Switch 17 - Not used (do not change any of these settings)
Communication Switch 18 - Not used (do not change any of these settings)
Communication Switch 19 - Not used (do not change any of these settings)
Communication Switch 1A - Not used (do not change any of these settings)
Communication Switch 1B
No. FUNCTION COMMENTS
0
1
2
3
4
5
6
7
Extension access code (0 to
7) to turn V.8 protocol On/Off
0: On 1: Off
If the PABX does not support V.8/V.34 protocol
procedure, set one of these bits to “1” to disable V.8.
Example: If “0” is the PSTN access code, set bit 0
to 1. When the machine detects “0” as the first
dialed number, it automatically disables V.8
protocol. (Alternatively, if “3” is the PSTN access
code, set bit 3 to 1.)