Ricoh aficio 1013F - Page 301

BIT SWITCHES
SM 5-29 B465
Fax Unit
B465
G3 Switch 05
No. FUNCTION COMMENTS
0–3 Initial Tx modem rate
Bit3210 Setting (bps)
0001 2.4 k
0010 4.8 k
0011 7.2 k
0100 9.6 k
0101 12.0 k
0110 14.4 k
0111 16.8 k
1000 19.2 k
1001 21.6 k
1010 24.0 k
1011 26.4 k
1100 28.8 k
1101 31.2 k
1110 33.6 k
Other settings - Not used
These bits set the initial starting modem rate for
transmission.
Use the dedicated transmission parameters if you
need to change this for specific receivers.
If a modem rate of 14.4 kbps or slower is selected,
V.8 protocol should be disabled manually.
Cross reference
V.8 protocol on/off - G3 switch 03, bit 2
4, 5 Initial modem type for 9.6 k or
7.2 kbps.
Bit 5 Bit 4 Setting
00V.29
01V.17
10V.34
11Not used
These bits set the initial modem type for 9.6 and 7.2
kbps, if the initial modem rate is set at these speeds.
6, 7 Not used Do not change these settings.
G3 Switch 06
No. FUNCTION COMMENTS
0-3 Initial Rx modem rate
Bit3210 Setting (bps)
0001 2.4 k
0010 4.8 k
0011 7.2 k
0100 9.6 k
0101 12.0 k
0110 14.4 k
0111 16.8 k
1000 19.2 k
1001 21.6 k
1010 24.0 k
1011 26.4 k
1100 28.8 k
1101 31.2 k
1110 33.6 k
Other settings - Not used
These bits set the initial starting modem rate for
reception.
Use a lower setting if high speeds pose problems
during reception.
If a modem rate of 14.4 kbps or slower is selected,
V.8 protocol should be disabled manually.
Cross reference
V.8 protocol on/off - G3 switch 03, bit 2