COPIER
SM 1-7 B044/B045/B046
Installation
10. Remove the foam cushion [A] and pull the
tabbed strips [B] all the way out of the
PCU. Then close the front door.
11. Pull open the paper tray, and remove the
tape [C] securing the end fence in the
compartment.
12. Push the bottom plate [D] down, load
paper, and adjust the side fences. If
loading paper shorter than A4, remove
the end fence [E] from its compartment,
set it into the tray, and adjust it to the
correct length.
13. Push the tray back in.
14. Adhere the appropriate branding decal
(not shown) to the center of the front
door [F], and adhere the tray number
decal and appropriate paper-size decal
to the front of the paper tray (at [G]) as
shown.
15. Hong Kong only:
If installing model B046 in Hong
Kong, you must change the position of
the TB1 jumper on the NCU. Turn to
the fax service manual and carry out
steps 4 to 8 of the installation
procedure (fax service manual, section 1.2.2).
16. Plug in the machine and turn on the main switch located on the left side of the
unit.
17. Enter SP mode (See 5.1 Accessing SP Mode), and run SP7-825 to initialize
the electrical total counter to 0.
NOTE:
1) After selecting SP7-825, enter "1" and then hold down the Original
Type key and press the OK key to initialize the counter. If
initialization is successful, the screen displays "Action completed."
2) SP7-825 is effective only once, at time of machine installation.
B046I104.WMF
B046I119.WMF
B046I515.WMF
[B]
[C]
[D]
[A]
[F]
[G]
[E]
To Next Page
Loading...
