DOCUMENT FEEDER
B044/B045/B046 1-18 SM
1. Unpack the ADF and remove the packing
tape from the bottom of the ADF body.
2. Remove the platen cover [A]. To
remove: Lift the cover, unlatch the
two latches [B] (press down on
the tabs [C] and push the latch
back), and detach the cover from
the hook [D].
3. Remove the left piece [E] of the copier's
platen cover by pushing the piece to the
left and then pulling it up and off.
4. Place the DF original table [F] flat onto
the platen cover, so that the 3 latches
go all the way into the openings and so
that the contact area [G] around each
latch is flush against the cover. Then
push so that latch [1] locks into place,
then latch [2], and then latch [3] (at the
rear left).
NOTE: The latches may break if you
try to push the table in at an
angle.
B046I505.WMF
B046I525.WMF
B046I526.WMF
[A]
[B]
[C]
[D]
[F]
[G]
[E]
[1]
[2]
[3]
To Next Page
Loading...
