System SP Table-1
SM Appendix 4-9 D009/D011/D012/D013/D091/D092
Appendix:
Service
Program
Mode Tables
1159
Fusing Jam Detection
SC Code Display
[0 to 1 / 0 / 1] 0:OFF, 1:ON
This SP setting determines whether SC559 is issued after three paper late
jams occur in the fusing unit. After this SP code is turned on, a counter
monitors the number of paper late jams that occur in the fusing unit. After
the 3rd occurrence of a fusing jam, SC559 is issued and the machine
cannot be used until the service technician releases the error.
Switching the machine off/on does not reset this jam counter. The
counter is reset after the cause of the jam has been removed and a
sheet of paper successfully passes the fusing exit sensor.
1801*
Motor Speed Adjustment
Adjusts the speeds of each motor. Each step decreases or increases motor
speed in 0.05% increments
Regist: Registration motor, Feed: Feed motor,
Duplex: Duplex/By-pass motor, Inverter: Duplex inverter motor,
Exit: Paper exit motor, Bridge: Bridge unit drive motor,
OpcMot: Drum motor, TransferMot: Transfer/Development Motor,
FusingMot: Fusing motor,
DevPuddleMot: Development Paddle motor
001 Regist: 90: Thick 2
[-2 to 2 / 0.4 / 0.05 %]
002 Regist: 154: Thick 1
003 Regist: 180: Plain
004 Regist: 230: Plain
005 Feed: 90: Thick 2
[-2 to 2 / -0.4 / 0.05 %]
006 Feed: 154: Thick 1
To Next Page
Loading...
