Ricoh D009 - Page 456

System SP Table-2
D009/D011/D012/D013/D091/D092 4-24 SM Appendix
2210*
P Pattern Cycle
Sets the interval between ID sensor pattern prints.
001*
Job Page Count
[0 to 200 / 10 / 1 sheet]
Sets the interval between ID sensor pattern printing. For users that do not
make many copies daily, set a smaller interval to compensate for the effects
of seasonal and weather changes.
002*
Forced Page Count
[2 to 999 / 100 / 1 sheet]
Sets the interval between ID sensor pattern printing.
Forces creation of the ID sensor pattern to prevent low density copies for
customers who use the copier for long copy jobs.
2213*
Toner End Setting
Selects the detection type for toner end.
[0 to 2 / 0 / 1 step]
[0: 90 copies, 1: No copies, 2: 10 copies]
 90 copies: Toner end is determined if a low density image (Vref <
Vt(10)) is detected 90 times after toner near end.
 If "1" is selected, the machine stops printing when the TD sensor
output drops below the prescribed level.
 Select 1 or 2 if the customer normally makes copies of very high
density.