Ricoh D009 - Page 695

Printer Service Table
SM Appendix 4-263 D009/D011/D012/D013/D091/D092
Appendix:
Service
Program
Mode Tables
SDK applications on data.
bit 3
[PS] PS Criteria
0: Pattern3 1: Pattern1
Change the number of PS criterion used by the PS interpreter to
determine whether a job is PS data or not.
Pattern3: includes most PS commands.
Pattern1: A small number of PS tags and headers
bit 4
Increase max number of the stored jobs
to 1000 jobs.
0: Disable
(100)
1: Enable
(1000)
Enable: Changes the maximum number of jobs that can be stored on the
HDD via Job Type settings to 1000. The default is 100.
bit 5 DFU - -
bit 6 DFU - -
bit 7 DFU - -
1001 Bit Switch
006 Bit Switch 6 0 1
bit 0
to 5
DFU - -
bit 6
PDL Auto Detection timeout of jobs
submitted via USB or Parallel Port (IEEE
1284).
0: Disable
(Immediately)
1: Enable
(10
seconds)
To be used if PDL auto-detection fails. A failure of PDL autodetection
doesn't necessarily mean that the job can't be printed. This bit switch tells
the device whether to time-out immediately (default) upon failure or to wait
10 seconds.
bit 7
This bitsw determines the timing of the PJL USTATUS JOB END sent when
multiple collated copies are being printed.
0 (default): JOB END is sent by the device to the client after the first copy has
completed printing. This causes the page counter to be incremented after the
first copy and then again at the end of the job.
1: JOB END is sent by the device to the client after the last copy has finished
printing. This causes the page counter to be incremented at the end of each
job.
⇒
Rev. 01/04/2011