Ricoh D025 - Page 602

System Service Mode
D023/D025 8-6 SM Appendix
008
Pressure Temp: Paper Feed: MT:
BW
*ENG
009 Pressure Temp: Paper Feed: MT: FC *ENG
010 Fusing Upper Limit Tem *ENG
[0 to 100 / 15/ 1 deg/step]
011 Offset: Feed Start *ENG
[0 to 100 / 25/ 1 deg/step]
012 Offset: Feed Start: Middle Thick *ENG
[0 to 100 / 10/ 1 deg/step]
031 Offset: Feed Start: F *ENG
032 Feed: Glossy: Ready : U limit *ENG
033 Offset: Feed Start: Glossy *ENG
040 1bin: Paper Feed: Pressure Temp *ENG
[0 to 100 / 85 / 1 deg/step]
041 F :1bin: Paper Feed: Pressure Temp *ENG
[0 to 100 / 75 / 1 deg/step]
1105 [Fusing Temperature] Fusing Temperature Adjustment
(Printing Mode, Roller Type, [Color], Simplex/Duplex)
Roller Type –> Center and Ends: Heating roller, Pressure –> Pressure roller
Paper Type -> Plain, Thin, Thick, OHP, Middle Thick, Special
Fusing Ready Temp. *ENG
[145 to 155 / 145 / 1 deg/step]
001
Specifies the heating roller target temperature for the ready condition.
Fusing Ready: Offset *ENG
[15 to 30 / 15 / 1 deg/step]
002
Sets the heating roller offset temperature for the printing ready condition.
Ready temperature = (Target temperature specified in SP1-105-1) –
Temperature specified in this SP mode