Ricoh G108 - Page 115

SERVICE PROGRAM MODE
SM 5-13 G108
Service
Tables
5507* Supply Alarm DFU
Enables or disables the supply alarm.
5507 001* Paper Supply Alarm
5507 003* Toner Supply Alarm
[0 to 1 / 0 / 1/step]
0: OFF, 0: ON
Sets the supply alarm level. Each supply alarm counter increases by +1 when a sheet of the
size is used. The supply alarm is issued when one of the supply alarm counter reaches the
specified value.
5507 128* Interval: Others
5507 133* Interval: A4
5507 134* Interval: A5
5507 142* Interval: B5
5507 164* Interval: LG
5507 166* Interval: LT
5507 172* Interval: HLT
[250 to 10000 / 1000 / 1/step]
5801 Memory Clear  5.1.4
5801 001 All Executes Engine SP5-801-003 through 014.
5801 003 SCS Clears the system settings.
5801 004 IMH Clears IMH data. DFU
5801 005 MCS Clears MCS data. DFU
5801 008 PRT Clears the printer application settings.
5801 011 NCS Initializes the system default and interface
settings (IP address also), SmartNetMonitor for
Admin, WebStatusMonitor settings, and the
TELNET settings.
5801 014 DCS Setting Clears or deletes the DCS-related data and
information.
5801 015 Clear UCS Setting Clears or deletes the UCS-related data and
information.
5801 016 MIRS Setting Clears or deletes the MIRS-related data and
information.
Destination 5808*
Shows the destination code.
5811 Serial Number
5811 002
Display Controller Serial
Number
5811 010
Display Engine Serial
Number
Shows the serial number.
5811 011 Set Engine Serial Number
Ask your supervisor for the information on this
SP.