SERVICE PROGRAM MODE
G108 5-16 SM
5839 IEEE 1394
5839 004* Host Name DFU
5839 007* Cycle Master DFU
5839 008* BCR mode DFU
5839 009* IRM 1394a Check DFU
5839 010* Unique ID DFU
5839 011* Logout DFU
5839 012* Login DFU
5839 013* Login MAX DFU
5840 IEEE 802.11b
Current SSID 5840 004*
Enters a unique ID (up to 32 characters long) to identify the device when it is
operating in an area with another wireless LAN network.
Channel Max [1 to 11 or 13 / 1 / 1/step]
Europe/Asia: 1 to 13
USA: 1 to 11
Note: Do not change the setting
5840 006*
Sets the maximum number of channels available for data transmission via the
wireless LAN. The number of channels available varies according to location.
The default settings are set for the maximum end of the range for each area.
Adjust the upper 4 bits to set the maximum number of channels. DFU
Channel Min [1 to 11 or 13 / 1 / 1/step]
Europe/Asia: 1 to 13
USA: 1 to 11
Note: Do not change the setting
5840 007*
Sets the minimum number of channels available for data transmission via the
wireless LAN. The number of channels available varies according to location.
The default settings are set for the minimum end of the range for each area.
Adjust the lower 4 bits to set the minimum number of channels. DFU
WEP key number [00~11 / 00 / 1 binary]
00: Key #1
01: Key #2 (Reserved)
10: Key #3 (Reserved)
11: Key #4 (Reserved)
5840 011*
Selects the WEP key.
5840 018 SSID Key Check Checks that the specified SSID is correct. The
result is displayed on the operation panel.
NOTE: You cannot use the characters other
than 0x20 ∼ 0x7e in an SSID. This SP is
commonly used among multiple machines. This
SP is for MFP machines, which can input
incorrect characters from various keys.
WEP mode [0~1/0/1]
0: Max. 64-bit (10 characters)
1: Max. 128-bit (10, 26 characters)
5840 020*
Determines the operation mode of the WEP key. Displayed only when the
option 801.11b for wireless LAN is installed.
To Next Page
Loading...
