SERVICE PROGRAM MODE
SM 5-15 G108
Service
Tables
NVRAM Upload 5824
Uploads the UP and SP mode data (except for counters and the serial
number) from the NVRAM to an SD card.
NVRAM Download 5825
Downloads the UP and SP mode data from an SD card to the NVRAM.
5828 Network
HD job clear
[0 to 1 / 1 / 1/step]
0: Data is cleared
1: Automatically printed
5828 066*
Treatment of the job when a spooled job exists at power on.
Job Spool (Protocol) [0 to 1 / 1 / 1/step]
0: Off, 1: On
Bit switch:
• Bit 0: LPR
• Bit 1: FPT
• Bit 2: IPP
• Bit 3: SMB
• Bits 4 to 7: Reserved
5828 069*
Switches job spooling off or on and allows settings for job spooling protocols.
5828 074* Delete Password Deletes passwords.
5828 084* Print Settings List Prints a list of NCS related parameters.
TELNET [0 to 1 / 1 / 1/step]
0: Disabled, 1: Enabled
5828 090*
Enables or disables Telnet.
Web [0 to 1 / 1 / 1/step]
0: Disabled, 1: Enabled
5828 091*
Enables or disables the Web monitor.
SMB Computer Name 5828 115*
Displays the SMB computer name.
SMB Workgroup Name 5828 116*
Displays the workgroup name.
HDD Initialization 5832
Initializes the hard disk. Use this SP mode only when a hard disk error occurs.
This SP initializes the whole area (the all partitions) in the hard disk.
To Next Page
Loading...
