SERVICE PROGRAM MODE
G108 5-18 SM
5857 Save Debug Log
On/Off [0 to 1 / 0 / 1/step]
0: Disabled, 1: Enabled
5857 001*
Enables or disables the debug log saving function.
Target [2 to 3 / 2 / 1/step]
2: Hard disk, 3: SD card
5857 002*
Selects the storage for the debug log.
Save to HDD 5857 005*
Specifies the key number of the debug log.
Save to SD 5857 006*
Specifies the key number of the debug log.
HDD to SD (4 MB) 5857 009*
Copies the latest 4 MB of debug log from the hard disk to the SD card.
HDD to SD (Any) 5857 010*
Specifies the key number of the debug log copied from the hard disk to the SD
card.
Erase HDD Log 5857 011*
Deletes the debug log from the hard disk.
Erase SD Log 5857 012*
Deletes the debug log from the SD card.
Free Space on SD 5857 013*
Displays the free space on the SD card.
SD to SD (4 MB) 5857 014*
Copies the latest 4 MB of debug log from an SD card to another SD card.
SD to SD (Any) 5857 015*
Specifies the key number of the debug log copied from an SD card to another
SD card.
5857 016* Make HDD Log File
5857 017* Make SD Log File
Generates a log file on the HDD to save debug
logs. To save debug logs, the controller
generates a log file first, and writes data in the
file afterward. This processing may take a long
time. The user may turn off the main power
switch before the log is written in the file. To
prevent this possible problem, you can prepare
a log file beforehand. The controller takes a
shorter time to save logs since the log file is
already generated.
To Next Page
Loading...
