Ricoh MP C307

1.Installation
16
6. Press [OK] after “Connection Test” has been successfully done.
7. Press [Exit] to terminate the System Settings.
Configuring the Remote Reception Settings
Do the following procedure to enable the Client-side Machine(s) to receive faxes via the Remote Machine. You
can forward or route received documents per line or special sender.
• By performing procedures described above (Installing the application in the Remote Machine and
Client-side Machine, Registering the Client-side Machine(s), Registering the Remote Machine), the
Client-side Machines can send faxes via the Remote Machine. The procedures shown below are
necessary to enable the Client-side Machines to receive faxes.
On the Remote Machine:
1) If you use "Remote Reception Setting per Line"
1. Press [Facsimile Features].
2. Press [Remote Reception Setting per Line] in [Reception Settings].
3. Enter an IP address or a host name of the client-side machine to connect.
4. Press [Set], and [Exit] to exit from the setting.
2) If you use "Remote Reception per Sender"
1. Press [Facsimile Features].
2. Press [Program Special Sender] in [Reception Settings].