4.Service Tables
62
1: Enabled "Original 2" can be selected in addition to the "Text", "Text/Photo" and
"Photo" modes.
* This setting can be used for the client machine which has no FCU.
System Switch 1A (SP No. 1-101-027)
No Function Comments
0
to
7
LS RX memory capacity
threshold setting
00-FF (0-1020 Kbyte:
Hex)
Sets the value to x4KB. When the amount of available memory drops below
this setting, RX documents are printed to conserve memory.
Initial setting 0x80 (512 KB)
NOTE: If a customer wants available memory size to be larger, decrease
this threshold
System Switch 1B - Not used (do not change these settings)
System Switch 1C - Not used (do not change these settings)
System Switch 1D (SP No. 1-101-030)
No Function Comments
0 RTI/CSI/CPS code
display
0: Enable
1: Disable
0: RTI, CSI, CPS codes are displayed on the top line of the LCD panel during
communication.
1: Codes are switched off (no display)
1-
7
Not used Do not change these settings.
System Switch 1E (SP No. 1-101-031)
No Function Comments
0 Communication after the Journal
data storage area has become full
0: Impossible
1: Possible
0: When this switch is on and the journal history becomes full, the
next report prints. If the journal history is not deleted, the next
transmission cannot be received. This prevents overwriting
communication records before the machine can print them.
1: If the buffer memory of the communication records for the Journal
is full, fax communications are still possible. But the machine will
overwrite the oldest communication records.
• This setting is effective only when Automatic Journal
printout is enabled but the machine cannot print the report
(e.g., no paper).
1* Action when the SAF memory
has become full during scanning
0: If the SAF memory becomes full during scanning for a memory
transmission, the successfully scanned pages are transmitted.
To Next Page
Loading...
