IMR02C15-E4
i-8
Page
6.3 Startup Tuning (ST) ....................................................................................6-11
Caution for using the Startup tuning (ST).............................................................6-11
Requirements for Startup tuning (ST) start...........................................................6-12
Requirements for Startup tuning (ST) cancellation...............................................6-12
Startup tuning (ST) setting....................................................................................6-13
6.4 Fine Tuning.................................................................................................6-17
To make control response faster..........................................................................6-17
To make control response slower.........................................................................6-18
6.5 Auto/Manual Transfer .................................................................................6-20
Bumpless function with Auto/Manual transfer ......................................................6-20
Auto/Manual transfer by front key operation.........................................................6-21
Auto/Manual transfer by digital input (DI) .............................................................6-22
Procedure for setting the Manipulated output value (MV) in Manual mode..........6-23
6.6 Protecting Setting Data (Data lock function)...............................................6-24
Set lock level ........................................................................................................6-24
Setting procedure flowchart..................................................................................6-24
Set lock level of Parameter setting mode .............................................................6-25
Locking all data which can be locked ...................................................................6-26
Selecting the parameter to lock............................................................................6-28
Locking F21 to F91 data.......................................................................................6-30
6.7 Display/No display Setting of Mode Screens ..............................................6-32
Hiding the parameters of the Monitor display mode .............................................6-34
Hiding the parameters of the Mode switching screen...........................................6-35
Hiding the parameters of the Parameter setting mode.........................................6-37
Displaying Function block 21 (F21) to Function block 91 (F91)
of the Engineering mode......................................................................................6-38
6.8 Interlock Release........................................................................................6-39
Interlock release by front key operation................................................................6-40
Interlock release by digital input (DI) ....................................................................6-41
7. OPERATING ADDITIONAL FUNCTIONS.........................7-1
7.1 SV Selection Function (Step SV function) ....................................................7-2
Setting procedure ...................................................................................................7-2
SV selection by front key operation ........................................................................7-3
SV selection by digital input (DI).............................................................................7-4
7.2 Timer Function..............................................................................................7-5
Control start (RUN) by Timer function (Timer function 1) .......................................7-5
Control stop (STOP) by Timer function (Timer function 2) .....................................7-7
Ramp/Soak control (Timer function 3, Timer function 4) ........................................7-9
To Next Page
Loading...
