IMR02C15-E4
i-7
Page
Digital input (DI1, DI2) [optional]...........................................................................3-13
Current transformer (CT) input [optional]..............................................................3-13
Communication [optional].....................................................................................3-14
3.4 Handling of the Terminal Cover [optional] ..................................................3-15
Mounting procedures............................................................................................3-15
Removal procedures ............................................................................................3-16
4. BASIC OPERATION..........................................................4-1
4.1 Operation Menu............................................................................................4-2
4.2 Changing Set Value......................................................................................4-4
5. SETUP PROCEDURES PRIOR TO RUNNING
THE INSTRUMENT............................................................5-1
5.1 Initial Setting .................................................................................................5-3
Check the parameter related to the input ...............................................................5-3
Check the parameter related to the event ..............................................................5-4
Check the parameter related to the control action..................................................5-5
5.2 Operation Setting..........................................................................................5-6
Set the control set value .........................................................................................5-6
Set the event set value ...........................................................................................5-7
5.3 Operation Start .............................................................................................5-8
Change from STOP to RUN ...................................................................................5-9
Tuning PID parameters ........................................................................................5-10
Start the Autotuning (AT) ..................................................................................5-10
To manually adjust the PID parameters............................................................5-11
Changing control response with Fine tuning.....................................................5-12
6. OPERATIONS OF THE BASIC FUNCTIONS ...................6-1
6.1 RUN/STOP Transfer.....................................................................................6-2
RUN/STOP transfer by front key operation ............................................................6-3
Performing RUN/STOP transfer in the “RUN/STOP setting” (Engineering mode)
..................................6-3
RUN/STOP transfer by digital input (DI) [optional] .................................................6-5
6.2 Autotuning (AT) ............................................................................................6-8
Caution for using the Autotuning (AT) ....................................................................6-8
Requirements for Autotuning (AT) start..................................................................6-8
Requirements for Autotuning (AT) cancellation......................................................6-8
Autotuning (AT) start/stop operation.......................................................................6-9
To Next Page
Loading...
