Signal Generation (Option R&S RTB-B6)
R&S
®
RTB2000
238User Manual 1333.1611.02 ─ 04
14.2.4.3 Timing Setup
Bit Time
Sets the time at which each sample is applied. The time is identical for all samples.
Remote command:
PGENerator:PATTern:STIMe on page 449
Period
Sets the period of the sample. It applies to the whole pattern. Period= Pattern Length *
Bit Time
Remote command:
PGENerator:PATTern:PERiod on page 449
Burst
If activated, the instrument pauses after each issued pattern for the duration of the "Idle
Time".
Remote command:
PGENerator:PATTern:BURSt:STATe on page 449
Idle Time
Sets the idle time, the time for which the instrument pauses after each issued pattern.
The "Idle Time" between the patterns can be set from 20 ns to 42 s in increments of 10
ns.
Remote command:
PGENerator:PATTern:ITIMe on page 449
N-Cycle
Sets the number of times the pattern is generated.
Remote command:
PGENerator:PATTern:BURSt:NCYCle on page 450
Pattern Generator
To Next Page
Loading...
