Rohde & Schwarz R&S RTB2004 - Page 436

Remote Control Commands
R&S
®
RTB2000
428User Manual 1333.1611.02 ─ 04
SEARch:PROTocol:LIN:FRAMe <Frame>
Selects the frame type to be searched for.
The command is relevant if SEARch:PROTocol:LIN:CONDition is set to FRAMe.
Parameters:
<Frame> SOF | WAKeup
SOF: start of frame
WAKeup: Wakeup frame
*RST: SOF
SEARch:PROTocol:LIN:IPERror
<IdParityError>
Searches for parity errors.
The command is relevant if SEARch:PROTocol:LIN:CONDition is set to ERRor or
IDERror.
Parameters:
<IdParityError> ON | OFF
*RST: OFF
SEARch:PROTocol:LIN:CHKSerror <ChecksumError>
Searches for checksum errors.
The command is relevant if SEARch:PROTocol:LIN:CONDition is set to ERRor or
IDERror.
Parameters:
<ChecksumError> ON | OFF
*RST: OFF
SEARch:PROTocol:LIN:SYERror <SyncError>
Searches for synchronization errors.
The command is relevant if SEARch:PROTocol:LIN:CONDition is set to ERRor or
IDERror.
Parameters:
<SyncError> ON | OFF
*RST: OFF
Serial Bus Analysis