Rohde & Schwarz R&S RTB2004 - Page 435

Remote Control Commands
R&S
®
RTB2000
427User Manual 1333.1611.02 ─ 04
Usage: Query only
15.11.6.4 LIN - Search
SEARch:PROTocol:LIN:CONDition..................................................................................427
SEARch:PROTocol:LIN:FRAMe...................................................................................... 428
SEARch:PROTocol:LIN:IPERror......................................................................................428
SEARch:PROTocol:LIN:CHKSerror................................................................................. 428
SEARch:PROTocol:LIN:SYERror.....................................................................................428
SEARch:PROTocol:LIN:ICONdition................................................................................. 429
SEARch:PROTocol:LIN:IDENtifier................................................................................... 429
SEARch:PROTocol:LIN:DLENgth.................................................................................... 429
SEARch:PROTocol:LIN:DCONdition................................................................................429
SEARch:PROTocol:LIN:DATA.........................................................................................430
SEARch:PROTocol:LIN:CONDition <SearchCondition>
Sets the event or combination of events to be searched for. Depending on the selected
event, further settings are required.
Parameters:
<SearchCondition> FRAMe | ERRor | IDENtifier | IDData | IDERror
FRAMe
Search for a frame type.
Set the frame type with SEARch:PROTocol:LIN:FRAMe.
ERRor
Search for errors of one or more error types.
Set the error types withSEARch:PROTocol:LIN:CHKSerror ,
SEARch:PROTocol:LIN:IPERror and SEARch:PROTocol:
LIN:SYERror.
IDENtifier
Search for identifier.
Specifiy the identifier with SEARch:PROTocol:LIN:
ICONdition and SEARch:PROTocol:LIN:IDENtifier.
IDData
Search for identifier and data.
Set the identifier (see IDENtifier) and the data with SEARch:
PROTocol:LIN:DLENgth, SEARch:PROTocol:LIN:
DCONdition and SEARch:PROTocol:LIN:DATA.
IDERror
Search for errors that occur with a specified identifier. Set the
identifier (see IDENtifier) and the errors to be found (see
ERRor).
*RST:
FRAM
Serial Bus Analysis