Remote Control Commands
R&S
®
RTB2000
435User Manual 1333.1611.02 ─ 04
To set the range of samples to be returned, use DIGital<m>:DATA:POINts.
Suffix:
<m>
.
0..15
Selects the logic channel
<p> 1..2
Selects the logic pod
Parameters:
<WaveformData> List of values according to the format settings.
Example:
FORM ASC,0
DIG1:DATA?
1,1,1,1,1,1,0,0,0,0,0,0,...
Usage: Query only
LOGic<p>:DATA:HEADer?
DIGital<m>:DATA:HEADer?
Returns information on the waveform of the specified logic channel/pod.
Table 15-6: Header data
Position Meaning Example
1 XStart in s -9.477E-008 = - 94,77 ns
2 XStop in s 9.477E-008 = 94,77 ns
3 Record length of the waveform in Samples 200000
4 Number of values per sample interval, usually 1. 1
Suffix:
<m>
.
0..15
Selects the logic channel
<p> 1..2
Selects the logic pod
Parameters:
<Header> Comma-separated value list
Example: -9.477E-008,9.477E-008,200000,1
Usage: Query only
LOGic<p>:DATA:POINts <PointSelection>
DIGital<m>:DATA:POINts <PointSelection>
As a setting, the command selects a range of samples that will be returned with
DIGital<m>:DATA?. As a query, it returns the number of returned samples for the
selected range.
Mixed Signal Option (Option R&S
RTB-B1)
To Next Page
Loading...
