Rohde & Schwarz R&S RTB2004 - Page 442

Remote Control Commands
R&S
®
RTB2000
434User Manual 1333.1611.02 ─ 04
Suffix:
<p>
.
1..2
Selects the logic pod
Parameters:
<State> ON | OFF
*RST: OFF
LOGic<p>:THReshold:UDLevel
Sets the threshold for the logic pod.
Suffix:
<p>
.
1..2
Parameters:
<ThresholdLevel>
15.12.1.3 Logic Channels - Waveform Data
For data queries and conversion, consider also the following commands:
●
FORMat[:DATA] on page 339
●
DIGital<m>:DATA:XINCrement? on page 347
●
DIGital<m>:DATA:XORigin? on page 347
●
DIGital<m>:DATA:YINCrement? on page 348
●
DIGital<m>:DATA:YORigin? on page 348
●
DIGital<m>:DATA:YRESolution? on page 349
●
LOGic<p>:DATA:XINCrement? on page 347
●
LOGic<p>:DATA:XORigin? on page 347
●
LOGic<p>:DATA:YINCrement? on page 348
●
LOGic<p>:DATA:YORigin? on page 348
●
LOGic<p>:DATA:YRESolution? on page 349
LOGic<p>:DATA?.......................................................................................................... 434
DIGital<m>:DATA?.........................................................................................................434
LOGic<p>:DATA:HEADer?............................................................................................. 435
DIGital<m>:DATA:HEADer?............................................................................................435
LOGic<p>:DATA:POINts.................................................................................................435
DIGital<m>:DATA:POINts...............................................................................................435
LOGic<p>:DATA?
DIGital<m>:DATA?
Returns the data of the specified logic channel/pod for transmission from the instru-
ment to the controlling computer. The waveforms data can be used in MATLAB, for
example.
To set the export format, use FORMat[:DATA].
Mixed Signal Option (Option R&S RTB-B1)