Rohde & Schwarz RTM2032 - Page 112

Measurements
R&S
®
RTM20xx
97User Manual 1317.4726.02 ─ 01
Reference Level: Upper, Middle, Lower Levels
Set the lower and upper reference levels for rise and fall time mesurements (cursor and
automatic mesurements) as well as the middle reference level used for phase and delay
measurements. The levels are defined as percentages of the high signal level. The set-
tings are valid for all measurement places.
Remote command:
REFLevel:RELative:MODE on page 341
REFLevel:RELative:LOWer on page 341
REFLevel:RELative:MIDDle on page 342
REFLevel:RELative:UPPer on page 341
Clear All
Resets and deactivates all four measurements.
Remote command:
MEASurement<m>:AOFF on page 335
Delay Setup
Configures the delay measurement that measures the time difference between two edges
of the same or different waveforms.
"Source 1,
Source 2"
Select one of the active channel, math or reference waveforms for each
measurement source.
"Slope"
Select the rising or falling slope for each measurement source.
Remote command:
MEASurement<m>:SOURce on page 338
MEASurement<m>:DELay:SLOPe on page 339
Phase Setup
Configures the phase measurement that measures the pahse difference between two
waveforms.
"Source 1,
Source 2"
Select one of the active channel, math or reference waveforms for each
measurement source.
Remote command:
MEASurement<m>:SOURce on page 338
Automatic Measurements