Rohde & Schwarz RTM2032 - Page 357

Remote Control
R&S
®
RTM20xx
342User Manual 1317.4726.02 ─ 01
REFLevel:RELative:MIDDle <MiddleLevel>
Set the middle reference level used for phase and delay measurements, if REFLevel:
RELative:MODE is set to USER. The level is defined as percentages of the high signal
level. The setting is valid for all measurement places.
Parameters:
<MiddleLevel> *RST: 50
Default unit: %
Firmware/Software: 03.400
15.2.8.5 Automatic Measurements - Statistic
MEASurement<m>:STATistics[:ENABle]..........................................................................342
MEASurement<m>:STATistics:WEIGht............................................................................342
MEASurement<m>:STATistics:RESet..............................................................................343
MEASurement<m>:RESult:AVG?....................................................................................343
MEASurement<m>:RESult:STDDev?...............................................................................343
MEASurement<m>:RESult:NPEak?.................................................................................344
MEASurement<m>:RESult:PPEak?.................................................................................344
MEASurement<m>:RESult:WFMCount?...........................................................................344
MEASurement<m>:STATistics:VALue:ALL?.....................................................................344
MEASurement<m>:STATistics:VALue<n>?......................................................................345
MEASurement<m>:STATistics[:ENABle] <StatisticEnable>
Activates or deactivates the statistical evaluation for the selected measurement.
Suffix:
<m>
.
1..4
Selects the measurement place.
Parameters:
<StatisticEnable> ON | OFF
*RST: OFF
Firmware/Software: FW 03.700
MEASurement<m>:STATistics:WEIGht <AverageCount>
Sets the number of measured waveforms used for calculation of average and standard
deviation.
Suffix:
<m>
.
1..4
Selects the measurement place.
Parameters:
<AverageCount> Range: 2 to 1000
Increment: 1
*RST: 1000
Command Reference