Data and File Management
R&S
®
RTM20xx
229User Manual 1317.4726.02 ─ 01
Words are given in Big Endian order - beginning with the MSB (Most Significant Byte)
and ending with the LSB (Least Significant Byte). Pairs of values are listed as two sub-
sequent single values, without any identification.
13.2.4.2 Saving a Waveform to USB flash drive
If you want to save many waveforms, you can assign the function to the PRINT key.
Infrequent savings can be started from the "File" menu. Before you can save the wave-
form, you have to configure the storage location and file format.
1. Press FILE > "Waveforms".
2.
Configure the storage location as described in "To select the storage directory"
on page 218.
3. Press "Waveform" and select the waveform to be stored. All active waveforms are
listed.
4.
Enter the file name as described in "To define a new file or directory name"
on page 218.
5. Select the "Format".
For details, see chapter 13.2.4.1, "Waveform File Formats", on page 227.
6. Press "Data" and select whether to save the displayed data or the data stored in the
memory.
For details, see "Data" on page 230.
7. Press "Save".
To save waveforms several times by pressing simply the PRINT key, assign the "Wave-
forms" to the PRINT key as described in chapter 13.2.2.1, "Configuring the PRINT-Key
Behavior", on page 224.
13.2.4.3 Waveform Storage Settings
With FILE > "Waveforms" you open a menu to store one of the active waveforms to a
USB flash drive.
For a description of the common save functions "Storage", "File Name", and "Save", see
chapter 13.2.1.3, "General Storage Settings", on page 220. Specific settings for saving
waveforms are described below.
Saving and Loading
To Next Page
Loading...
