Rohde & Schwarz RTM2032 - Page 313

Remote Control
R&S
®
RTM20xx
298User Manual 1317.4726.02 ─ 01
Return values:
<Bandwidth> Range: 1,00E+006 to 2,00E+009
Increment: 10
Default unit: Hz
Usage: Query only
PROBe<m>:SETup:CAPacitance?
Queries the input capacity of the probe.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Return values:
<InputCapacitance> Range: 0.1e-12 to 1.0e-9
Increment: 1.0e-12
Default unit: F
Usage: Query only
PROBe<m>:SETup:DCOFfset?
Retrieves the DC voltage that is measured by the integrated voltmeter of R&S active
probes. Switch the voltmeter on before, see PROBe<m>:SETup:OFFSwitch
on page 299.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Return values:
<Offset> Range: -1.0e26 to 1.0e-26
Increment: 1,00E-003
Default unit: V
Usage: Query only
PROBe<m>:SETup:IMPedance?
Queries the termination of the probe.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Return values:
<Termination> 50OHm | 1MOHm | UNKNown
Usage: Query only
Command Reference