Rohde & Schwarz RTM2032 - Page 314

Remote Control
R&S
®
RTM20xx
299User Manual 1317.4726.02 ─ 01
PROBe<m>:SETup:MODE <Mode>
Select the action that is started with the probe button.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<Mode> RCONtinuous | RSINgle | AUToset | NOACtion
RCONtinuous
Run continuous: The acquisition is running as long as the probe
button is pressed.
RSINgle
Run single: starts one acquisition.
AUTOSET
Starts the autoset procedure.
NOACtion
Nothing is started on pressing the micro button.
*RST: RCONtinuous
PROBe<m>:SETup:NAME?
Queries the name of the probe.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Return values:
<Name> string
Usage: Query only
PROBe<m>:SETup:OFFSwitch <DCOffsetOnOff>
Switches the integrated voltmeter of an R&S active probe on or off.
The command is only available if an R&S active probe with R&S ProbeMeter is used.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<DCOffsetOnOff> ON | OFF
*RST: OFF
PROBe<m>:SETup:TYPE?
Queries the type of the probe.
Command Reference