Rohde & Schwarz RTM2032 - Page 348

Remote Control
R&S
®
RTM20xx
333User Manual 1317.4726.02 ─ 01
Usage: Query only
CURSor<m>:YDELta:SLOPe?
Returns the inverse value of the voltage difference - the reciprocal of the vertical distance
of two horizontal cursor lines: 1/ Δ V.
Suffix:
<m>
.
1
The numeric suffix is irrelevant.
Return values:
<DeltyYslope> Inverse value
Usage: Query only
CURSor<m>:
YDELta[:VALue]?
Queries the delta of the values in y-direction at the two cursors.
Suffix:
<m>
.
1
The numeric suffix is irrelevant.
Return values:
<DeltaY> Delta value in V
Usage: Query only
CURsor<m>:XRATio:UNIT <Unit>
Sets the unit for X Ratio measurements with CURSor<m>:XRATio[:VALue]?.
Suffix:
<m>
.
1
The numeric suffix is irrelevant.
Parameters:
<Unit> RATio | PCT | GRD | PI
RATio - floating value
PCT - percent
GRD - degree
PI - radian
*RST: RAT
CURSor<m>:XRATio[:VALue]?
Returns the ratio of the x-values (e.g. a duty cycle) between the first and second cursors
and the first and third cursors: (x2-x1)/(x3-x1).
Set the unit of the result with CURsor<m>:XRATio:UNIT.
Command Reference