Show CCs on Key Bus
Sets whether or not custom controls that are attached to
crosspoint buttons on the keyer bus are shown on the
keyer mnemonics.
Press HOME > Setup > Personality and use the
Option knob to select Show CC on Key Bus.
• Off — show the source name in the source
mnemonics.
• On — show the name of the custom control attached
to a source button on the mnemonic.
Show Last CC Pressed
Allows you to keep the last pressed custom control button
lit after the custom control has îš¿nished. The button
remains lit until another custom control is pressed or the
switcher is reset. This is shown for each custom control
bank independently.
Press HOME > Setup > Personality and use the
Option knob to select Show Last CC Pressed.
1. Use the Value knob to turn the feature on or off.
• Off — do not continue to light the custom
control button after the custom control has
îš¿nished.
• On — continue to light the custom control button
after the custom control has ended.
2. Use the Color knob to select the color you want the
custom control button to be lit with.
Show Last Mem Recalled
Allows you to keep the last pressed memory number lit
after you have recalled a memory on the same bank. The
button remains lit until another memory is recalled or
the switcher is reset. This is shown for each effects
memory module independently.
Press HOME > Setup > Personality and use the
Option knob to select Show Last Mem Recalled.
• Off — do not light the last memory number you have
recalled.
• On — light the last memory number you have
recalled, if the memory is in the same bank.
Store Mode
Sets whether or not a memory module remains in store
mode after a memory has been stores, or switch to recall
mode.
Press HOME > Setup > Personality and use the
Option knob to select Store Mode.
• Hold — Global Memory module or the Effects
Memory module stay in store mode after a memory
has been stored.
• 1-Time — Global Memory module or the Effects
Memory module switch to recall mode after a
memory has been stored.
Swap Keyer Cut & Auto
Allows you to swap the behavior of the CUT and AUTO
TRANS buttons on the Keyers module. When this feature
is set to swap, the CUT button performs an auto
transition, and the AUTO TRANS button performs a
cut.
Press HOME > Setup > Personality and use the
Option knob to select Swap Keyer Cut&Auto.
• Swap — CUT and AUTO TRANS buttons on all
keyers modules swap their functions. The CUT button
performs an Auto Trans.
• Normal — transition buttons on the keyers modules
keep their original functions.
Swap PGM/PST Buses
Allows you to swap the functions of the Program bus to
the Preset bus on all MEs. When this feature is turned
on, the sources that you select on the preset bus act as if
they are being selected on the program bus, and the
sources selected on the program bus act as if they are
being selected on the preset bus.
Press HOME > Setup > Personality and use the
Option knob to select Swap PGM/PST Buses.
• Swap — Program and Preset buses on all MEs
swapped.
• Normal — Program and Preset buses keep their
original functions.
Swap Trans Cut & Auto
Allows you to swap the behavior of the CUT and AUTO
TRANS buttons on the Transition module. When this
feature is set to swap, the CUT button performs an auto
transition, and the AUTO TRANS button performs a
cut.
Press HOME > Setup > Personality and use the
Option knob to select Swap Trans Cut&Auto.
• Swap — CUT and AUTO TRANS buttons on all
Transition modules swap their functions. The CUT
button performs an Auto Trans.
• Normal — transition buttons on the Transition
modules keep their original functions.
Acuity Setup Manual (v9.2) — Personality • 49
To Next Page
Loading...
Need help?
General
