Configuring the Access Point
Configuring Wireless Settings
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 129
3 Click Update Settings to save your settings.
Band Selection on ZoneFlex 7321
The ZoneFlex 7321 is a dual band selectable (2.4 GHz or 5 GHz) single radio Access
Point. This means it can operate on the 2.4 GHz band or the 5 GHz band at any
time, but not both at the same time. You can select the radio band from the
Configuration > Wireless page, as shown in Figure 64.
Advanced Settings Refer to “Configuring Common Advanced Settings” on
page 130
.
AeroScout RFID Select
Enabled to support AeroScout RFID tag detection.
To check the status of the AeroScout communication agent
(which relays location data from AeroScout Tags to the
AeroScout Engine), go to the Status > Wireless page. Refer
to Viewing Common Wireless Settings for more information.
NOTE: For other AeroScout-related configuration, refer to
the AeroScout documentation that was shipped with your
AeroScout Tag and AeroScout Engine.
NOTE: If ZoneDirector exists on the network, then you can
enable AeroScout RFID tag detection on all its managed APs
at once. Refer to the ZoneDirector online help for more
information.
Ekahau RFID Select Enabled to support Ekahau RFID tag detection, and
then enter the IP address and port number of the Ekahau Real
Time Location System Controller (ERC).
External Antenna
NOTE: This option only appears if you are using the ZoneFlex
7372-E AP.
The ZoneFlex 7372-E AP provides an external antenna port
which allows you to attach an external antenna to extend the
range of your wireless network. To enable the AP to use the
external antenna, select the
Enabled option in this section. This
option is disabled by default.
Table 46. Common Wireless settings (Continued)
To Next Page
Loading...
