Configuring the Access Point
Configuring Internet Settings
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 122
3 Enter a PPPoE Username.
4 Enter a PPPoE Password.
5 Retype the password in PPPoE Password Confirmation.
6 To allow the DNS mode to be determined automatically, set IPV4 DNS Mode to
Auto.
To set the DNS mode manually, set IPV4 DNS Mode to Manual. Then enter the
following:
• IPv4 Primary DNS Server: The IP address of the primary Domain Name
System (DNS) server.
• IPv4 Secondary DNS Server (optional): The IP address of the secondary DNS
server.
7 Click Update Settings to save your changes.
Configuring L2TP Connection Settings
You can implement transparent bridging with ZoneFlex through the use of L2TP
(Layer 2 Tunneling Protocol) tunneling. By tunneling traffic from a ZoneFlex AP to a
centralized data center, access controllers with policy enforcement software can
apply rules and services. In a typical WLAN implementation, these rules include a
captive portal to authenticate users’ credentials.
In the case of L2TP, the ZoneFlex AP functions as a remote bridge. As such, it
forwards traffic into PPP sessions over the L2TP tunnel. This implementation
ensures that you have complete visibility into MAC addresses of users, as individual
Wi-Fi clients are essentially placed (bridged) onto the ISP’s core network.
1 Go to Configuration > Internet.
To Next Page
Loading...
