Configuring the Access Point
Configuring Wireless Settings
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 142
Setting Threshold Options
The following options allow you to fine-tune the “Protection Mode” behavior, set
previously on the Configuration > Wireless > Advanced > Common page. After
activating a Protection Mode, you can open each Wireless tab and customize the
threshold settings, which determine what is put into effect and when.
CAUTION! Do not customize these options unless you are an experienced network
administrator or are under the guidance of an IT/support professional.
1 Go to Configuration > Wireless or Configuration > Radio 2.4G or
Configuration > Radio 5G. The Configuration > Wireless > Common page
appears.
2 Click the tab for the Wireless # (WLAN) that you want to configure. The
Configuration > Wireless > Wireless [#] page appears.
3 Look for Threshold Settings, and then click Edit Settings. The Configuration
> Wireless > Advanced > Wireless [#] page appears.
Figure 70. Threshold settings
To Next Page
Loading...
