Configuring the Access Point
Configuring Internet Settings
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 118
Configuring NTP Server and Management VLAN
NTP Server
A Network Time Protocol (NTP) Server should be configured to ensure that the
Access Point maintains the correct time. The default Ruckus Wireless NTP Server
(ntp.ruckuswireless.com) can be used if you do not have an NTP server on your
network.
If you want the AP to contact a different NTP server, you can do so by going to
Configuration > Internet and entering the host name in NTP Server at the top of
the page.
Management VLAN
CAUTION! Changing the Management VLAN causes you to be immediately
disconnected from the Web interface if the computer you are using is not on the
same VLAN. Do not change the Management VLAN unless your admin PC is on
the same VLAN, or you are disconnected and unable to connect again without
factory resetting the AP.
If you want to place this AP’s management traffic into a management VLAN, enter
the VLAN ID in the Management VLAN field and click Update Settings.
Default IP Addressing Behavior
By default, the Access Point is configured to automatically obtain an IPv4 address
from a DHCP server on the network. If the Access Point does not detect a DHCP
server, it automatically assigns itself the static IP address 192.168.0.1 to make
it easier for you to preconfigure and deploy it on your network.
For IPv6, the Auto Configuration setting serves the same purpose as DHCP. The
default static IPv6 address is fc00::1.
Obtaining and Assigning an IP Address
There are three methods of assigning IP addresses to the Access Point:
• DHCP / Auto Configuration
• Configuring Static IP
• PPPoE
To Next Page
Loading...
