Configuring the Access Point
Configuring Internet Settings
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 119
DHCP / Auto Configuration
If you leave the Access Point at its default configuration, it attempts to obtain an
IPv4 address from a DHCP server on the network.
In an IPv6 network environment, the AP attempts to obtain an IPv6 address from
an IPv6 Auto Configuration server.
Renewing and Releasing DHCP
This task should be performed only if you have access to the DHCP server or have
some way to determine what IP address has been assigned to the AP. It serves as
a troubleshooting technique when IP addresses to one or more networked devices
are unusable or in conflict with others, or when the AP loses its DHCP-assigned IP
address for some reason.
1 Go to Status > Internet.
Figure 59. Renew or Release DHCP
2 Review the current settings.
3 If the current Connection Type is DHCP, you are able to see the currently-
assigned IP address and subnet mask listed below.
• To force the AP to release its DHCP-assigned IP address, click Release
DHCP. This disconnects the user from Web interface as the system reverts
to its default IP address. Log in to the device using the default IP address
(192.168.0.1) and click on Renew DHCP to request a new lease from the
DHCP server.
To Next Page
Loading...
