Installing the Access Point
Step 1: Preconfigure the Access Point
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 84
Step 1: Preconfigure the Access Point
The procedure for completing the Access Point’s essential configuration depends
on whether you want it to be managed by either ZoneDirector or FlexMaster or to
operate as a standalone Access Point. Refer to the section that is relevant to your
deployment:
• Configuring for Management by ZoneDirector
• Configuring for Standalone Operation or for Management by FlexMaster
Configuring for Management by ZoneDirector
If ZoneDirector is installed on the network, follow the instructions in the ZoneDirector
User Guide and connect the AP to your network.
NOTE The Access Point must have some way of obtaining an IP address (IPv4
DHCP or IPv6 Auto Configuration).
CAUTION! If you configure an AP for management by ZoneDirector and later
decide that you want it to be a standalone AP, you need to factory reset the AP.
Configuring for Standalone Operation or for
Management by FlexMaster
This section describes the steps you need to complete to set up the AP in standalone
mode or to be managed by a Ruckus Wireless FlexMaster server, if you have one
installed on the network. Continue with the following:
• What You Will Need
• 1. Prepare the Administrative Computer
• 2. Connect the Access Point to the Administrative Computer
• 3. Log Into the Access Point’s Web Interface
• 4. Configure the Wireless Settings
• 5. Disconnect the Access Point from the Administrative Computer
• 6. Restore the Administrative Computer’s Network Settings (Optional)
What You Will Need
Before starting with the configuration task, make sure that you have the following
requirements ready:
To Next Page
Loading...
