Managing the Access Point
Enabling Other Management Access Options
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 172
Pointing the AP to FlexMaster
Your ZoneFlex device is required to “call home” to register with your FlexMaster;
FlexMaster does not initiate initial contact. To register successfully with FlexMaster,
your ZoneFlex device must know the FlexMaster server’s URL, thus entered on the
device. You need TCP ports 80 and 443 between APs and FlexMaster when
traversing Layer 3/firewall boundaries.
1 Go to Administration > Management.
2 Under TR-069/SNMP Management Choice, click Auto.
3 In FlexMaster Server URL, type the URL of the FlexMaster server.
4 Tog g le t h e Periodic FlexMaster Inform Interval drop-down list to select how
frequently the device checks the FlexMaster server for any pending configuration
changes available for that ZoneFlex unit. On the FlexMaster side, this field is
referred to as the Periodic Inform Interval.
5 Click Update Settings to save your changes.
After the AP registers with FlexMaster, this Administration > Management page will
show the communication status between the AP and FlexMaster.
Current Time Shows the current date and time as known to the AP. This
timestamp is accurate if an NTP server is configured on
the AP. If there is no NTP server configured, this timestamp
is useful as a reference for comparison of the timestamps
for
Last attempted contact and Last successful
contact
.
Table 60. TR-069 status information (Continued)
Status Information Description
To Next Page
Loading...
