Installing the Access Point
Step 2: Verify Access Point Operation
ZoneFlex Indoor Access Point 9.8.1 User Guide, 800-70601-001 Rev C 95
Check the TR069 Status (FlexMaster Management
Only)
If you configured the Access Point to report to a FlexMaster server on the network,
make sure you verify that it can successfully communicate with the FlexMaster
server. You can do this by checking the TR069 status on the Access Point’s Web
interface.
1 Log in to the Access Point’s Web interface.
2 Go to the Administration > Management page.
3 Scroll down to the TR069 Status section.
4 Check the value for Last successful contact. If it shows a date in green, this
indicates that the Access Point was able to successfully communicate with
FlexMaster.
Disconnect the Access Point from the Network
1 Disconnect the Access Point from the power source.
2 Disconnect the Ethernet cable that runs to the Access Point’s RJ45 port from
your network’s router or switch.
You are now ready to deploy the Access Point to its permanent mounting location.
To Next Page
Loading...
